✓ Verified
Wyoming Marine
Boat Shop · Repair services
3100 Conestoga Drive, Gillette, WY 82718
Website
Rigging · WY · 6 marine listings
Yacht Rigging in Wyoming
Browse marine providers across Wyoming. Standing and running rigging — inspection, replacement, and tune-ups.
About this service
Standing rigging (wire shrouds and stays) is what holds the mast up. Running rigging (sheets, halyards, control lines) is what makes the sails work. Both have predictable lifespans — standing rigging 10–15 years, running rigging 5–10 — and both fail in expensive, often catastrophic ways when ignored. A qualified rigger can inspect, tune, and replace rigging at a small fraction of the cost of a dismasting.
Marine providers in Wyoming
4 shownNo exact rigging matches yet — these are notable marine shops in Wyoming. Many marinas and yards offer rigging without naming it explicitly.
Related reading
Best Sailboat Hardware (2026): Blocks, Clutches, Winches & Running Rigging
Sailboat hardware fails quietly until it doesn't. Our top picks for 2026 across blocks, clutches, winches, and running rigging — what to upgrade and what to skip.
Sail Trim Basics for Cruisers: Make Your Boat Move Better
Most cruising sailors are leaving 1-2 knots on the table from poor sail trim. A practical, racing-free guide to trimming the main and genoa for performance and comfort.
10 Essential Marine Knots Every Yacht Owner Should Know
Most boating problems can be solved with one of ten knots. Learn the bowline, cleat hitch, clove hitch, and more — when to use each, plus common mistakes.
Frequently asked
- How often should standing rigging be replaced?
- Stainless steel standing rigging on a regularly-sailed cruising boat should be replaced every 10–15 years even without visible damage — fatigue cracks at swage fittings are invisible until they fail. Insurance underwriters increasingly require documented rigging inspection or replacement after 15 years.
- What does standing rigging replacement cost?
- For a typical 40-ft cruising sailboat, full standing rigging replacement (all wire, swages, and turnbuckles) runs $4,000–$10,000 in 2026 depending on rig configuration (sloop, cutter, ketch), wire diameter, and labor market.
- How often should a rig be tuned?
- After major weather events, after re-stepping the mast, and annually as part of spring commissioning. Most riggers offer tune-as-you-sail service where they ride along on the first sail of the season to fine-tune in actual sailing conditions.